I thought I understood the pic, but I guess I don't. ] to spray over the black? I wasn't sure if it would go over the black ok and if putting this kind of paint on the screen would make it flammable when there is a fire in the fireplace next to it?Ī. My question is can I buy a Krylon metallic spray paint in the matte nickel finish I bought a black wrought iron fireplace screen because I loved the look of it and it only came in this color. My name is Valerie & this seems like a helpful site regarding finishing metal surfaces. And again, the painter's mask - you don't want your lung sacs coated with even a little bit of black paint :-) Always wear at least a dust mask and eye protection when sanding anything whatsoever.īBQ spray paint is fine as a topcoat ], but paint sticks poorly to brass even if it is sanded, so try a self-etching primer first. But it is not good for your lungs to breathe dusts or small particles of anything. Brass is not a hazardous material requiring collection it's an alloy of copper and zinc, which are both essential micronutrients, not toxins. Should I collect it and dispose of it somehow? Should I wear a face mask? Fran LymanĪ. ![]() This was recommended by two powder-coaters who thought the high heat of their process might warp the metal and not enable the paint to bake to sufficient temperatures to be used in a fireplace.Īre there any dangers or cautions in hand-sanding a brass-plated metal? I have a hand sander and I've started, but don't know if I should allow the brass metal dust to dust up into the environment. I want it black and have "BBQ black" for the job. So it's been suggested to me that I simply take it outside and (after laying it out on cardboard), spray paint it to give it a nice new even coating. ![]() The old pink marble around it is going to be changed out to a nice contemporary earthy slate. I have an old fireplace screen from the seventies that I wanted to clean up and dress up. Then you can hopefully paint them with whatever color paint you wish. Paint doesn't stick well to brass, so scrub them first with a scrub brush and laundry detergent or trisodium phosphate, then use a Self-Etching Primer to get some tooth. If they are plated, the plating is probably worn through so your choices would be limited to sending them to a plating shop for re-plating, or to paint them. If solid brass, they can be re-polished, although it may be a bigger job than you want to do yourself. Test with a magnet to see if they are non-magnetic solid brass (unlikely) or magnetic brass plated steel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |